Change of Relay Position

The mains input filter is now connected to the power supplies and they have connected to the battery charging circuits and relay drive circuit.  This unit is what can be seen in the photo to this post.

PSU and Control PCB.

PSU and Control PCB.

The next thing to connect are the relays that have already been connected to the batteries – see the last post “Battery Pack”.  However, I have realised that the relays attached to the batteries would be better placed in another position; closer to the control board relays.

So I now have to disassemble the relays from the batteries and put them on their own pcb, right next to the pcb shown here.  This will give shorter and fewer wire runs.

Advertisements

About Matal

Hand made HiFi, photos, a friends poetry.
This entry was posted in Construction, Power Supplies and tagged , , . Bookmark the permalink.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s